ISO9001 ISO14001
    Solution provider with 15 years in adhesive&sealant industry

epoxy for electronics with good electrical properties

SATOP®8668 midium viscosity low CTE epoxy structural adhesive

epoxy for electronics
epoxy for electronics
epoxy for electronics

 

Feature of epoxy for electronics

  • This product is a heat curing type, has a good temperature resistance, low total chlorine.
  • Need to heat curing, and needs low temperature (below 10 ℃).
  • After curing, it has strong toughness, high bonding strength at the bonding site, impact resistance, and shock resistance.
  • The cured product has good acid and alkali resistance, moisture proof, waterproof, oil proof and dustproof performance, heat resistance and atmospheric aging.
  • The cured product has good electrical and physical properties such as good insulation, compressive strength, and bonding strength.

potting material

Before curing:

ItemTest methods or conditionsTest Results
Appearance(shore D)Transparent liquid
ViscosityΩ·cm, 25℃1100±300
DensityΩ, 25℃1.10±0.05
Curing conditions(KV/mm, 25℃150℃/30min

After curing:

ItemTest methods or conditionsTest Results
Hardness(shore D)>80
Volume resistivityΩ·cm, 25℃1.0×1015
Surface resistanceΩ, 25℃2.2×1014
Dielectric strength(KV/mm, 25℃>18

Using process:

Bonded parts need to be kept dry and clean, When using epoxy adhesive, it takes 1-1.5 hours to warm up after taking it out of the oven, and it takes 30 minutes to cure it after being dispensed into a 150℃ oven.

During the curing process, if the amount of glue applied is too much or the temperature is too high, yellowing may occur. In such cases, reduce the curing temperature appropriately.

Precautions of epoxy for electronics

  • Because the product is heated reacts to chemical products, so the effect of environmental temperature on the product quality is very big, please send the product stored in low temperature environment, in order to ensure the stability of the product and quality. After taking out the unused colloid, please cover it tightly and put it back into the frozen environment.
  • Few people contact adhesive solution for a long time will produce mild skin irritation, itch had mild pain, it is recommended to use when wear protective gloves, please with skin with acetone or alcohol wipe, and use cleaner clean.
  • Before using it in large quantities, please try it out in small quantities and master the skills of using the product so as to avoid mistakes.

Packing:

30ml/pcs

8ml/pcs

Storage and transportation of epoxy for electronics

This product should be sealed in low temperature, cool and dry place.

Shelf life:  3 months(under the – 30 ℃) 

 

Product safety information is not included here. Before use, please read the product information, product safety information and packaging label for safe use. The product safety information can be obtained from SATOP and the distributor, or write to the SATOP service center [email protected] or call 021-64243697.

The technical data of this paper are all typical values obtained under laboratory conditions.We are not responsible for the results of methods beyond our control.Because users use condition is different, different material surface state, curing conditions, storage conditions, transportation and other factors can make gum stability and physical and mechanical properties, the actual performance data has some changes are normal phenomenon.Before using this product,Validation is based on the data provided in this article.If you have any problems with the process, you can contact our technical service department and we will provide you with all the help. Our company reserves the right to modify the data in this article



Email
  • Michael
Skype
  • Michael
  • Julie
Wechat
  • Scan for better chat